The system may prompt you that the disk is unavailable and needs to be formatted, please ignore it, it is not an error! When "Flash Complete!" appears, it means that the system has been successfully programmed into the Micro SD card. Click Flash ! Wait patiently, the program will write the system to the Micro SD card. After installation, start Etcher, insert the Micro SD card to PC, select the img file to be installed and the disk partition corresponding to the Micro SD card. After flash, disconnect the DC power and OTG USB cable, make sure the device is completely disconnected, and then connect the power to start. When the terminal shows green word "Done", it means the burning is finished. Run the following command to download file, and start to burn system to eMMC. The address in the command above is full path of unzipped system installation package. For example: cd D:\Desktop\NXP\i.MX8MP\BMB-09\desktop_BMB09 Type the command to enter the system installation package directory. The DEBIX Model A mentioned above needs a DIP switch and an eMMC module. USB mode status of DEBIX SOM A I/O Board is DIP switch set to “0001”.USB mode status of DEBIX Model A/B is DIP switch set to “01”.Connect PC to OTG interface of the device using USB cable, press and hold the flash key on device or set DIP switch to “ USB mode ”, and connect DC power to enter the USB flash mode. Download system installation package that we provide to DEBIX, check if the MD5 matches after the download is complete, and then unzip it on PC.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |